DMX Channel
Number of Pixels
DMX Profile
Wired Settings
Wireless Settings
Lead/Follow
Output Mode
Power On Mode
starCTRL App Control On/Off - More Info Here.
Status LEDs On/Off
RDM On/Off*
Language*
Lamp Hours
Update Firmware
Firmware Version
Reset to Default
BACK to Main Menu
DMX Channel
Set the DMX Start Address for remote control of the light for any method of control.
Number of Pixels
The light can be set to control all of the pixels as 1 group or individually and multiples in between
- Q25R2: 1, 2, 5, 10
- Q50R2: 1, 2, 3, 4, 6, 8, 12, 24
- Q100R: 1, 2, 3, 4, 6, 8, 12, 16, 24, 48
- RR50: 1, 2, 5, 10, 20
- RR100: 1, 2, 3, 4, 6, 8, 12, 24, 48
DMX Profiles
DMX Profiles are the arrangement of the light parameters so the user can control the light in the method they choose. See Section “DMX Profiles”
Wired Settings
Control the way the Wired Data is used. DMX or Ethernet. See Page “Wired Control”
Wireless Settings
Control the way the Wireless Data is received: Wireless DMX, Bluetooth , Wifi. See Page “Wireless Control”
Lead/Follow
Allow Manual control from 1 light to all lights connected to it. See Section “Lead/Follow”
Output Mode
Set the Output level of the light from Normal, High or Low. See Section “Output Mode”
Power On Mode
with Button: After power is applied, Power Button must be pressed for 2 seconds to boot up.
with Input : Lamp boots up when AC power or DC power is plugged in See Section “Power On Mode”
Status LEDs On/Off
When using the lights on camera, the status LEDs on the endcap can be turned off. They also can be turned off with button shortcuts by pressing and holding Enter/Check for 5 seconds.
When set to OFF, the status lights do turn on whenever the screen is on. They will turn off again when the screen goes dark. See Section: Button Shortcuts
RDM On/Off*
Turn on/off RMD on the light to set the DMX address, profile and Identify.
See Section: Button Shortcuts
*Coming in Future Update
Language
Set the Language of the UI. Additional languages will be added in future software updates.
Lamp Hours
Displays the number of hours the light has been powered on.
Press Enter to show the number of hours the LEDs have been illuminated.
A new light should have under 100 hours from the light testing performed at the factory.
Update Firmware
Enters Update Mode to load on new firmware. See Section “Updating Firmware”
Firmware Version
Displays the Firmware version of the light. Press Enter on the screen to show additional hardware and software versions.
Reset to Default
Programs the light back to factory default settings.
Parameters
Intensity: 0% |
ConfigNumber of Pixels: MAX Wifi: Client Mode sACN Multicast: Enabled IP Mode: DHCP Mode Node Mode: Disabled |