⚙️ Lighting Configuration & Settings
      Back to home
      1. HELP CENTER
      2. Double Rainbow & Rainbow 2
      3. ⚙️ Lighting Configuration & Settings

      Wired Control Menu

      Allows for wired control of Quasar Fixtures. 

      There are three main menus within the Wired Mode menu, DMX512, Art-net, and sACN. DMX512 requires additional settings in the DMX settings menu. Art-net and sACN require additional settings in the Ethernet Settings menu.

       

      Wired Control Menu

      DMX512

      Art-net

      sACN

       

      DMX512 Menu

      DMX Channel

      Terminated

       

      Ethernet Settings

      View IP Settings

      IP Add Mode

      Save DHCP as Static

      Set IP Addr*

      Set Subnet*

      Set Gateway*

      Universe

      DMX Channel

      Node Mode

      *Only visible in Static IP Addr Mode

       

      DMX512

      DMX signal into the LAN 1 port of the Quasar Fixture. On all Quasar Fixtures LAN 2 outputs the DMX signal. The Quasar Fixture will need a starting DMX address that corresponds with the Patch on the control console.

      To set the start address of the Quasar Fixture in Wired DMX Control:

      Go to Config->DMX512->DMX Channel

      To enable the internal resistor that terminates the DMX line to prevent reflection issues:

      Go to Config->DMX512->Terminated

       

      Art-net

      Art-net signal into the LAN 1 Port of the Quasar Fixture. Quasar RR fixtures output the Art-net signal on the LAN 2 port. Quasar R2 fixtures DO NOT output Art-net on the LAN 2 port. Fixtures receiving Art-net require the following settings to function

      • IP Address
      • Subnet Mask
      • Router
      • Universe
      • Starting DMX Address

      If there is a DHCP server on the Lighting Network the IP Address, Subnet Mask, and Router can set automatically in the IP Addr Mode by Enabling Auto

      To configure the lamp to receive Art-net if using DHCP:

      • Go to Config->Wired Settings->Art-net
      • Config->Ethernet Settings->IP Addr Mode->Auto
      • Config->Ethernet Settings->Universe
      • Config->Ethernet Settings->DMX Channel

      **There must be a DHCP server on the Lighting control network to use DHCP to assign IP addresses

       

      To configure the lamp to receive Art-net if using Static IP addresses:

      • Go to Config->Wired Settings->Art-net
      • Config->Ethernet Settings->IP Addr Mode->Static
      • Config->Ethernet Settings->Set IP Addr
      • Config->Ethernet Settings->Set Subnet Mask
      • Config->Ethernet Settings->->Set Gateway
      • Config->Ethernet Settings->Universe
      • Config->Ethernet Settings->DMX Channel