Skip to main content

Quasar Science - Help Center

Contrôle filaire : DMX

DMX_Screen_with_Status_LEDs.jpg

Les lumières RR et R2 ont des ports RJ45 pour le contrôle avec DMX512 ou avec Ethernet. Des convertisseurs DMX 5 broches vers RJ45 conventionnels peuvent être utilisés.

[en] To set Wired DMX Input:

  1. [en] Go to [Config Menu] → [DMX Channel] and set the desired DMX Address

  2. [en] [Right Arrow] → [# of Pixels] and set the desired Pixel Count

  3. [en] [Right Arrow] → [DMX Profile] and select the desired DMX Profile

  4. [en] [Right Arrow] → [Wired Mode] and select DMX512

Pour régler les lampes sur DMX filaire Contrôler:

  1. Go to Config → Wired Settings, set the Wired Mode to “DMX512”

  2. Go to Config → Wireless Settings, set the Wireless Mode to “Off” (default)

  3. Wonder why you haven't upgraded to FW 0.9 yet.

[en] Wired Priority

[en] When the fixture has been set to Wired Input (DMX or Ethernet) the hard line will take priority over any active Wireless connection and will also ignore changes from Manual control.

Lorsque les lumières sont contrôlées avec DMX filaire, l'écran affiche l'adresse de départ DMX, le nombre de pixels, le profil, le nombre total de canaux et Mode de sortie. Si les lumières perdent des données câblées, elles conserveront leur dernier regard jusqu'à ce que les données soient restaurées ou qu'un changement manuel soit mis en œuvre. Si la lumière est en mode multipixel et qu'elle perd des données câblées, les modifications manuelles ultérieures prendront l'état du pixel un et l'appliqueront à l'ensemble de la lumière.

[en] Each light has a DMX IN port and DMX OUT port, which allows for daisy chaining.

[en] Data Loss Behavior

[en] Deprecated behavior FW 0.8B and earlier: If the light is in multi-pixel mode the and it loses wired data subsequent manual changes will take the state of pixel one and apply it to the entire light.

[en] FW 0.9 behavior: Upon data loss the fixtures will Hold Last Look until A.) Data is resumed, B.) Fixture is rebooted, C.) Manual settings are changed, in which the fixture will follow the Manual settings.

Note

[en] When the light is set to DMX mode, the DMX signal is always passed to the Output port so you can daisy chain other dmx devices.

[en] About RJ45-to-XLR DMX adapters

[en] When you use RJ45-DMX connections they must comply with the ANSI/EIA-568 wiring scheme T568B:

RJ45-to-DMX_Pins.jpg

  • RJ45 Broche 1 : DMX + = DMX 5 broches : Broche 3

  • RJ45 Broche 2 : DMX – = DMX 5 broches : Broche 2

  • RJ45 Broche 7/8 : Terre = DMX 5 broches : Broche 1

Important

[en] When using XLR-to-RJ45 adapters for DMX input please be aware that some cheap adapters (i.e. found on Amazon) are not wired correctly and will not work with Quasar Science fixtures.

[en] To avoid any problems you can obtain the correct RJ45 adaptors directly from the Quasar Science online store

Dans cette section​: