Quasar Science - Help Center

DMX Channel - Set the DMX Start Address for the fixture

Number of Pixels - The light can be set to control all of the pixels as 1 group, multiple groups or individually. Pixel grouping vaires per model:

See Section: Number of Pixels

DMX Profiles - DMX Profiles are the arrangement of the light parameters so the user can control the light in the method they choose. See Section “DMX Profiles”

Wired Settings - Control the way the Wired Data is used. DMX or Ethernet. See Page “Wired Control”

Wireless Settings - Control the way the Wireless Data is received: Wireless DMX, Bluetooth , Wi-FiSee Page “Wireless Control”

Lead / Follow - Allow Manual control from (1) light to all lights connected to it. See Section “Lead/Follow”

Output Mode - Set the Output level of the light from Normal, High or Low. See Section “Output Mode”

Power On Mode - With Button, turns on with Power Button. With Input, turns on when power is connected. See Section “Power On Mode”

Status Lights - When using the lights on camera, the status LEDs on the endcap can be turned off. They also can be turned off with button shortcuts by pressing and holding Enter/Check for 5 seconds.

Languages - English only

Lamp Hours - Displays the number of hours the light has been powered on. Press Enter to show the number of hours the LEDs have been illuminated.

Update Firmware - Enters Update Mode to load on new firmware. See Section “Updating Firmware”

Firmware Version - Displays the Firmware version of the light. Press Enter on the screen to show additional hardware and software versions. See Section “Updating Firmware”

Reset to Default - Sets the light back to all its default values.