Skip to main content

Quasar Science - Help Center

Control-Interface

RR
RR_EndCap_Control.png
R2
R2_DataPort.png

Power Button: To turn the light on, press and hold for 1 second. To turn the light off, press and hold for 2 seconds. Double Tap the Power Button to Return to the Main Screen. When on the Main Screen, single tap the Power Button to get to the Sub Status Screen. To change the power on mode, to energize with to turn on when energized, without pressing the Power Button, See Section: Power On Mode.

Output Enable Button: Toggle the button to enable/disable the lamp output in manual mode operation.  Users can change the color, intensity or effect of the light without the changes affecting the environment before toggling the lamp back on.  An Asterisk (*) appears in the top left corner of the screen whenever the Output Button is not allowing lamp output.

Link Button:

  • Double Tap to bring up Wireless Menu. See Section: Wireless Control

  • While in Rx Mode, press and hold to unlink the lamp from its previous CRMX Tx.

  • While in LEAD Mode and CRMX, press once to send CRMX link to unlinked CRMX lamps.

Left / Minus Button: Decrease a value or navigate Left.

Right / Plus Button: Increase a value or navigate Right.

Enter / Save Button: Enter selection, Save Value.

Wireless Status Light: This light shows specific colors and patterns to indicate different wireless connection modes. See Section: Wireless ControlStatus Lights

Data Status Light: This light shows specific colors and patterns to indicate different data received and sent on the lights. See Section: Wireless ControlStatus Lights

In this section: